Small metal fence recommendations and ideas

[mullacc]

I need a 21 foot fence with gate fabricated/installed in the next few weeks. It will need to meet pool fencing regulations.

Because I have only one door to the backyard I just need to the enclose my patio with a straight fence that spans from a block wall to the block laundry room, rather than have a fence that goes all the way around my pool. The downside of this is that the fence will be very prominent, so it needs to look good but I would like be able to see through the fence so as not to visually enclose my patio.

So I was hoping to get recommendations for a metal fabricator. And also I wanted to know if anyone has any ideas/photos/recommendations for the design of a pool fence. My idea, that works with the pool fence regulations, is to make a fence out of a series of the rectangular frames with a 1 inch wire mesh inside of the frames, and one of the frames would swing as the gate.



patio fence diagram [Converted] by armccallum

[mstuckey]

I am also interested in recommendations for modern pool fences design. Anyone have some ideas or references?

[PixelPixie]

Try Joe at jobuiltconstruction.com and tell them Modernphoenix sent you!

[mullacc]

Well, I never put up that pool fence and now I am committed to doing it very soon (next week or two if possible). So I will ask again.

Does anyone have a recommendation for a metal fabricator that would be able to fabricate and install a 21 foot pool fence. I have a designs that I think any experienced fabricator could put together.



The mesh would be much smaller than in the is drawing (1 3/4" or less), but this is the basic idea. The entire 21 feet is across existing concrete patio.